T-16 Standard engine, Would consider a forged bottom end

piggy22 · Post by **piggy22** » Sat Dec 08, 2012 8:10 pm

As Above. I am wanting a bottom end and a head. Not fussed about any thing else because i can just swap mine over
It must be a healthy quiet engine and i would prefer to hear it running

My heads tapping its nuts off and the bottom end has a distinct knocking and i cant get the crank seal to stop leaking

so im going to take it out

I dont have the time for a full rebuild and i think i can get this swapped in a day

I dont mind how far anyone is away, im always up for a good drive

Thanks in advance

BootydoZs · Post by **BootydoZs** » Sat Dec 08, 2012 10:33 pm

a few bare t16's on ebay atm but a bit pricey around 250-350 squids.

http://www.ebay.co.uk/itm/Rover-Turbo-6 ... 25786cfe64

http://www.ebay.co.uk/itm/ROVER-600-620 ... 460a87dbd6

http://www.ebay.co.uk/itm/Rover-620-ti- ... 232549824e

notroubleclubber · Post by **notroubleclubber** » Sun Dec 09, 2012 12:47 am

Vard had a 820 engine that might be useful.

harland292 · Post by **harland292** » Sun Dec 09, 2012 4:38 pm

Iv got a standard complete head mate

piggy22 · Post by **piggy22** » Sat Dec 15, 2012 11:50 pm

Still looking for one of these

Would prefer head and block

syzsounds · Post by **syzsounds** » Sun Dec 16, 2012 10:06 am

Got a removed nearly complete 220 lump with no head and a semi rebuilt 820 lump if your interested ... just want em out of the garage tbh.
Might have a head knocking around .. tbh i havent been in the garage since the temps dropped below 4 degrees !

05zrturbo · Post by **05zrturbo** » Sun Dec 30, 2012 6:27 pm

got a engine mate no turbo or gearbox still complete ish if your interested was strong and good runner kept as spare pm me

notroubleclubber · Post by **notroubleclubber** » Sun Dec 30, 2012 7:20 pm

I might be interested.
Please pm me with a price and I'm not too far.

Rovertech 2.0

T-16 Standard engine, Would consider a forged bottom end

T-16 Standard engine, Would consider a forged bottom end

Re: T-16 Standard engine, Would consider a forged bottom end

Re: T-16 Standard engine, Would consider a forged bottom end

Re: T-16 Standard engine, Would consider a forged bottom end

Re: T-16 Standard engine, Would consider a forged bottom end

Re: T-16 Standard engine, Would consider a forged bottom end

Re: T-16 Standard engine, Would consider a forged bottom end

Re: T-16 Standard engine, Would consider a forged bottom end